Roger Technology B71/PBX Instrucciones Y Advertencias Para El Instalador página 68

11.12RTCC menu (FUTURE USE, with B71/PBX/RTCC)
The indicated data is only indicative.
buffer battery. It connects via dedicated wiring to the ADTSER connector of the B71/PBX. y
SERIAL
WIFI
COM
POWERSAVE
RTCC
ENTER
RTCC SET
TX CODING
N. CODES
COMMAND
ENTER
Return to the previous menu
68
ESC
RDY
FIX
85/500
----
ESC
ATTENTION! Remember to enable serial communication
(par. 11.9) and to select TARGET RTCC.
ADJUST RTCC transfers the time previously set on
B71/PBX (in the EVENTS/DATE AND TIME menu) to the
RTCC device, which then takes over the precise time
management. This operation can only be carried out if
the status RDY appears.
- NO if not detected RTCC connected
- RDY if RTCC detected, ready to command
- ASK when ENTER is pressed, the command is
launched ADJUST RTCC
- OK adjustment performed; after 3 seconds
the indication RDY
With TX CODE TYPE it is possible to select the type of
decoding of the RTCC receiving section, which can be:
- FIX Fixed code (max 500 codes)
- ROL Rolling code (max 250 codes)
ATTENTION! Changing the setting causes the receiver
memory to be completely erased.
N. CODES Indicates the number of TX codes (keys)
stored in B71/PBX/RTCC (e.g. 85/500)
COMMAND provides information about the received
command:
- RX1, RX2 indicates the radio function of the receiver
which has been activated by the radio control
- CMD indicates that the command comes from a
button connected to the external external
command input of RTCC
The indication disappears automatically after 1 sec.
COM