MSA ALTAIR 4 Manual De Instrucciones página 455

MSA
To Charge the Instrument
• Firmly insert the instrument into the charging cradle.
The battery symbol
•
number of segments until 90% of full charge has been obtained. Then it
will remain fully illuminated while the battery is trickle charged to its full
capacity.
• If a problem is detected during charging, the battery symbol will flash.
Remove then replace the instrument in the charging cradle to reset the
charge cycle.
2.2.8 Operating Beep
This operating beep activates every 30 seconds by momentarily beeping
the horn and flashing the alarm LEDs under the following conditions:
• Operating beep is enabled
• Instrument is on normal Measure Gases page
• Instrument is not in battery warning
• Instrument is not in gas alarm
• Audible and visual options are enabled
2.3 Viewing Optional Displays
The Main Screen appears at instrument turn-on.
Optional displays can be viewed by pressing the [
2.3.1 Bump Mode
To select the Bump mode, press the [
To move forward, press the [
To move backward to the Main page, press the [
2.3.2 Peak Readings (PEAK page)
The peak icon
instrument since turn-on or since peak readings were reset.
To reset the peak readings:
(1) Access the PEAK page.
(2) Press the [
GB
DECLARATION OF CONFORMITY CONTENTS
will scroll through a progressively increasing
] button.
shows the highest levels of gas recorded by the
] button.
ALTAIR 4 - Operating Manual 10088160/00 Y-HLR
] button to move to:
] button.
] button.
15