MSA ALTAIR 4 Manual De Instrucciones página 469

MSA
3.4 Instrument Setup
This section describes the configuration options that are available through the
Options Setup menus. These menus can be accessed only when the
instrument is turned on while pressing and holding the [
(see Sections 3.2 and 7.3).
This mode can only be activated at instrument turn-on.
The operation is as follows:
(1) Press and hold the [
• Use the [
The default password is "672".
(2) Press [
• Incorrect password: instrument enters the Measure mode.
• Correct password: instrument continues/beeps three times.
The password can be changed through the MSA Link software.
In the Setup mode:
• Press the [
• Press [
off.
• Press and hold [
• Press [
off.
Press and hold [
The following options are available by pressing the [
• Sensor Setup (
Calibration Setup (
•
• Alarm Setup (
• Setup Time and Date (
•
EXIT
GB
DECLARATION OF CONFORMITY CONTENTS
] button while turning the instrument on.
] and [ ] buttons to enter the setup password.
] button to enter the setup menus.
] button to store chosen value or go to the next page.
] button to increase values by one or toggle a selection on or
] button to increase values by 10.
] button to decrease values by one or toggle a selection on or
] button to decrease values by 10.
SENSOR SETUP
CAL SETUP
ALARM SETUP
TIME SET
ALTAIR 4 - Operating Manual 10088160/00 Y-HLR
] and [
) - see Section 3.4.1
) - see Section 3.4.2
) - see Section 3.4.3
) - see Section 3.4.4
] button
] buttons:
29