MSA ALTAIR 4 Manual De Instrucciones página 471

MSA
3.4.2 Calibration Setup
The user can change and set the calibration values for each sensor.
It is also possible to select whether the Cal Due screen is displayed and set
the number of days until the next calibration is due.
For more information, see the flow charts in Section 7.7.
COMB/EX
CO
Figure 3-3
(1) To bypass this setup, press the [
as follows.
(2) Press the [
• The calibration gas concentration of the first sensor is shown.
(3) Press the [
(4) Press the [
• Setup screen for the next sensor is displayed.
(5) Repeat the procedure for all other sensors.
• After setting the last sensor, the user is prompted to set CALDUE.
(6) Press the [
Press the [
(7) If CALDUE is set on, press the [
number of days
(8) Confirm with the [
(9) After confirmation, continue to Alarm setup.
GB
DECLARATION OF CONFORMITY CONTENTS
O2
H2S
Calibration Setup
] button to enter the submenu.
] button or the [
] button to store the value.
] button or the [
] button to confirm the selection.
] button.
ALTAIR 4 - Operating Manual 10088160/00 Y-HLR
] or [ ] button; otherwise, continue
] button to change the value.
] button to enable or disable CALDUE
] or the [ ] button to select the
31