LAVAZZA INOVY COMPACT Instrucciones De Empleo página 37

N° Problem encountered
Water leaks at the front side of
5
the coffee machine.
Water leaks at the rear side of
6
the coffee machine.
The loading lever does not
reach the supply position or
7
requires an excessive closing
effort.
Warning lights / ON
flashing and ESPRESSO
8
button ON with steady
light.
Warning lights / ON
flashing and ESPRESSO
9
button ON with light
flashing.
Warning lights /
ON flashing and LONG
10
ESPRESSO button
with steady light.
Warning lights /
ON flashing and LONG
11
ESPRESSO button
with light flashing.
TROUBLESHOOTING
Possible causes
1 - Spent capsule drawer not
inserted correctly.
2 - Spent capsule drawer
filled.
3 - Capsule stuck.
4 - Capsule not compatible.
1 - Tank not inserted correctly. Insert the tank correctly.
2 - Tank damaged.
1 - Spent capsule drawer
filled.
2 - Capsule fitted incorrectly.
1 - Machine damaged, CPU
error.
1 - Machine damaged,
software error.
1 - The temperature
measured inside the
machine is lower than
ON
5°C or higher than the
maximum allowed value.
1 - Power supply damaged.
ON
Solution
Insert the spent capsule drawer
correctly.
Empty the spent capsule drawer
and the drip tray.
Lift and lower the capsule
loading lever. If this is not
enough, disconnect the machine
from power mains and operate
manually to remove the capsule
from the duct.
Use Lavazza capsules or
compatibles.
Check for leaks in the tank
keeping it separate from the
machine.
Empty the spent capsule drawer.
Repeat the sequence, lever in
the off position, lever in the
brewing position; if this is not
enough, operate manually
to remove the capsule from
the duct with the machine
disconnected from power mains.
Power cycle the machine.
Power cycle the machine.
Allow the machine to rest at
ambient temperature for the
necessary time.
(N.B. Depending on the initial
temperature, this time may be of
up to 2 hours).
Power cycle the machine.
EN
Result
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: go to step 3
Ok: call solved.
Non-ok: go to step 4
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
37