Publicidad
Idiomas disponibles
Idiomas disponibles
2 Safety
1.5 Classification of the warnings
The warnings used in the operating instructions are divided into four different levels and shown prior to
potentially dangerous work steps. The following signal words are used depending on the type of hazard:
Describes an imminent threatening danger. If not avoided, it may cause severe injuries or death.
Describes a potentially dangerous situation. If not avoided, this may result in death or serious injuries.
Describes a potentially harmful situation. If not avoided, this may result in slight or minor injuries.
NOTICE
Describes the risk of impairing work results or material damage and indicates irreparable damage to the
device or equipment.
2 Safety
This chapter describes the product-specific safety requirements and warns of residual hazards that should
be kept in mind to operate the product safely. Non-observance of the safety instructions may result in risks
to the life and health of personnel, and environmental damage or material damage.
► Please observe the attached "Safety Instructions" document.
► Consult the documentation for additional welding components.
2.1 Designated use
The device described in these operating instructions may be used only for the purpose and in the manner
described in these operating instructions. Unauthorized modifications or changes to enhance the
performance are not permitted.
► Do not exceed the maximum load data as defined by the documentation supplied. Excessive loads lead
to irreparable damage.
► Do not make any constructive changes to this product.
2.2 Obligations of the operator
► Ensure that only qualified personnel are permitted to perform work on the device or system.
Authorized personnel are:
— those who are familiar with the basic regulations on occupational safety and accident prevention;
— those who have been instructed on how to handle the device;
— those who have read and understood these operating instructions;
— those who have read and understood the attached "Safety Instructions" documentation;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their special training, knowledge,
► Keep untrained persons out of the work area.
EN - 4
DANGER
WARNING
CAUTION
and experience.
MF3-Laser Front/Rear
Publicidad
