Abicor Binzel MF3-Laser Front/Rear Manual De Instrucciones Original página 30

7 Operation
7 Operation
7.1 Inserting or replacing the wire feed rolls
The following wire feed rolls are each available for the corresponding wire diameters:
— Wire feed roll with V-groove for hard wires (e.g., CuSi 3/steel/stainless steel)
— Wire feed roll with U-groove for soft wires (e.g., aluminum wires)
EN - 12
MF3-Laser Front/Rear
Open the housing cover at the lug and lift the
1
cover up.
Push the clamping lever up to release the latch.
2
Swivel the rocker arm to the side.
3
To release the drive rolls (C), turn the quick-clamp
4
device (B) counterclockwise by 90°.
To loosen the pressure rolls, unscrew the quick-
5
clamp device of the rocker arm (A) and pull it
A
upwards.
B
C
Remove the drive rolls upwards.
6
Remove the pressure rolls from the side of the
7
rocker arm.
Insert new drive rolls and pressure rolls.
8
Attach again in reverse order.
9