Publicidad
Idiomas disponibles
Idiomas disponibles
MF3-Laser Front/Rear
4.3 Technical data
*
**
*** See 7.2 Setting the contact pressure on page EN-13.
Tab. 2
Connection voltage
Idle speed
Idle current
Starting torque
Max. continuous current
Continuous torque
Max. angular acceleration
Negative EMF constant
Torque constant
Terminal resistance
Motor regulation R/k²
Terminal inductance
Rotor moment of inertia
Mechanical time constant
Tab. 3
Number of pulses
Power supply
Max. current consumption*
Phase shift A/B**
Max. frequency**
Moment of inertia of the disc
Output voltage, high level*
Output current, high level**
Output voltage, low level**
Output current, low level**
Tab. 4
Max. contact pressure/wire feed roll***
Wire feeder speed
Gearbox ratio
Drive type
Roll diameter
Protection class
Wire diameter
Max. gas pressure
Weight of drive unit
Weight with bracket
1 Depends on the selected gas hose
Use of the max. values for all three parameters is not permitted.
Electrical properties apply only to the range of operating temperatures.
Motor data
Data for encoder motor
Mechanical data drive
4 Product description
32 V
5900 rpm
80 mA
756 nNm
2.3 A
115 mNm
64 10³rad/s²
5.40 rpm
52 mNm/A
2.20 Ω
0.83 10³/Nms
0.40 mH
71.4 kgm² × 10¯
6 ms
300
5 ± 10% V
15 ± 3 mA
90 ± 60 °e
60 kHz
5.2 gmm²
2.4–5 V
−0.2 mA
0–0.4 V
8 mA
225 ± 40 N
1 – max. 10 m/min
30:1
2 powered rolls
20 mm
IP 21
0.8–1.6 mm
1
10
bar
2273 g
2715 g
7
EN - 9
Publicidad
