Fluke db PRUFTECHNIK SHAFTALIGN touch Informacion General página 2

This safety and general information document contains safety and
information symbols that are relevant while using the system. The
document contains detailed laser safety information. The following
handling aspects are also dealt with: storage, care, maintenance,
disposal and transport. Safety specifications, FCC requirements, notes
on data storage, general information, and system warranty form part
of this document.
Contents subject to change without further notice, particularly in the
interest of further technical development.
Safety
Safety symbols
The CAUTION symbol denotes information which must
be followed in order to avoid damage to equipment.
The WARNING symbol denotes information which must
be followed in order to avoid personal injury.
The laser safety warning symbol denotes laser radiation.
The Electrical hazard symbol is used to identify elec-
trical hazard and high voltage areas.
Denotes conformity to requirements of European Union
and European Free Trade Association.
Denotes that any waste electrical and electronics parts
of the system including memory sticks must be disposed
of according to applicable safety and environmental
regulations.
Denotes that the product is made of parts that are
recyclable.
General safety
To prevent possible electrical shock, fire, or personal injury:
 Read all safety information before you use the system.
 Carefully read all instructions.
 Use the system only as specified, or the protection supplied by
the system can be compromised.
 Make sure machines are locked out, tagged out, and cannot be
started accidentally or deliberately during maintenance.
 Do not use the system around explosive gas or vapour.
 Use only the external mains power supply included with the
system.
 Do not charge the system components while inside its carrying
case.
 The batteries of the system components must not be allowed
to fully discharge (a minimum charge capacity of 15% is
acceptable).
 Do not use the system if it operates incorrectly.
 Use only specified replacement parts.
 Have an authorized PRÜFTECHNIK service centre repair the
system.
WARNING