Argo X3I ECO PLUS 27 HL WF Manual De Instalacion Y Uso página 106

Step six: install the condensate drain pipe
1. Connect the drain pipe to the outlet pipe of
the indoor unit.
2. Bind the joint with tape.
N.B.:
• Add an insulating tube to the indoor drain pipe to
prevent condensation.
• The plastic wall plugs are not supplied.
Step seven: connect the indoor unit electrical
cable
1. Open the panel. Remove the screw that secures
the small panel covering the terminal board.
2. Insert the indoor and outdoor unit connecting
cable into the rear hole corresponding to the
terminal block. Then pull it out of the front.
3. Remove the cable clip. Connect the power cable
to the terminal block according to colour. Tighten
the screw and secure the power cable with the clip.
Note: the link card is only for reference, plase take into consideration the actual one.
106