Argo X3I ECO PLUS 27 HL WF Manual De Instalacion Y Uso página 69

 Bear in mind that the appliance is filled with flammable gas R32.
Improper handling of the device creates the risk of serious injury to
persons and damage to materials. Details of this refrigerant can be
found in the "refrigerant" chapter.
 Check that the maintenance area or room surface meets the
requirements of the identification plate.
 Use is only permitted in premises that meet the requirements indicated
on the identification plate.
 Check that the maintenance area is adequately ventilated.
 Continuous ventilation conditions must be maintained during the
operation process.
 Check that the area intended for maintenance does not present any
sources of ignition, even potential ones.
 The introduction of naked flames in the maintenance area is
prohibited, while the posting of the "no smoking" sign is mandatory.
 Check that the equipment markings are in good condition.
 Replace any unclear or damaged warning marks.
 Check for the presence of flammable gases with the appropriate
detector before unloading and opening the container.
 Do not introduce combustion sources and do not smoke.
 Comply with local laws and regulations.
 The use of the air conditioner is not allowed in rooms with an open
flame (for example, combustion sources, coal gasification systems, gas
heating systems).
 It is not allowed to drill holes or burn the connecting pipe.
 The air conditioner must be installed in a room larger than the
minimum area of the room. Check the minimum area of the room on
the identification plate or on the table a.
 At the end of the installation it is necessary to perform a leak test.
 Instructions for installing and using this product are provided by the
manufacturer.
Operating limits
Cooling mode: from -15°C to +43°C (outdoor temperature)
Heating mode: from -15°C to +24°C (outdoor temperature)
69