Argo X3I ECO PLUS 27 HL WF Manual De Instalacion Y Uso página 99

Was the unit restarted immediately after
shutdown?
Is the setting on the remote control correct?
The indoor unit's Is the indoor temperature and humidity high? Indoor air cools rapidly. Wait for the
air outlet
produces a mist
Is the unit operating in automatic mode?
The set
temperature
cannot be
adjusted Does the desired temperature fall outside the
available temperature range?
Is the voltage too low?
The desired
level of Is the filter dirty?
heating/cooling Does the set temperature fall within the
cannot be available temperature range?
achieved
Are there any doors or windows open?
The unit is Is there an odour source (e.g. furniture,
emitting cigarettes, etc.)?
unpleasant
smells
The air Are there any sources of interference (e.g.
lightning, wireless devices, etc.)?
conditioner
turns on
suddenly
Has heat mode been selected?
The outdoor unit
produces steam
Has the air conditioner recently been turned
Sound of
on or off?
running water
Has the air conditioner recently been turned
on or off?
Creaking/cracki
ng noises
Wait 3 minutes and then restart the unit.
Reset the function.
indoor temperature and humidity to fall
and the mist to disappear.
The temperature cannot be adjusted in
automatic mode. Change the operating
mode if you want to adjust the
temperature.
The available temperature range is: 16 –
30°C.
Wait for the voltage to return to normal.
Clean the filter.
Adjust the temperature to within the
available range.
Close any doors and windows.
Eliminate the odour source.
Clean the filter.
Disconnect the power supply and then
reconnect it. Turn the unit on again.
Steam production when defrosting in heat
mode is a normal phenomenon.
The noise is produced by the refrigerant
flowing inside the unit (normal
phenomenon).
It is the sound of the friction caused by the
expansion and/or contraction of the panel
or other parts due to temperature changes.
99