Argo X3I ECO PLUS 27 HL WF Manual De Instalacion Y Uso página 109

Step two: install the drain joint
1. Connect the outdoor drain joint into the hole
on the chassis, as shown below.
2. Connect the drain hose into the drain hole.
NB: As for the shape of drainage hose, please
refer to the current product. Do not install the
drainage hose in the severe sold area, otherwise
it will be frosted and then cause malfunction
Step four: connect the indoor and outdoor pipes
1. Remove the screw on the right-hand handle of the
outdoor unit and remove the handle.
2. Remove the screw cap of the valve and position
the pipe joint in the bellmouth of the pipe.
Step three: secure the outdoor unit
1. Position the outdoor unit on the support.
2. Secure the foot holes of the outdoor unit with
bolts.
.
3. Pre-tighten the union nut by hand.
4. Tighten the union nut with the wrench
according to the following table.
Hex nut diameter
6.35
9.52
12.7
15.88
109
Tightening torque (Nm)
15 – 20
30 – 40
45 – 55
60 – 65