Publicidad
Technical Information
Remote I/O connection
All the input/output remote signals to/from the controller must be connected at P1
mating connector. With the provided J1 mating connector make the connection with
AWG 24 (0.25 mm
desired capability. It is a 15-pins D type connector; the available signals are detailed
in the table, the following paragraphs describe the signal characteristics and use.
Figure 50
Table 6
Component
Remote I/O Signal Listing
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
Pin 11
Pin 12
Pin 13
Pin 14
Pin 15
184
2
) or smaller wire to the pins indicated in the figure to obtain the
Description
Start/Stop
Not used
Not used
Not used
Not used
Not used
Not used
Not used
+24 V +/- 10 %, max. current 80 mA
Output relay
Output open drain
Output relay
Not used
Analog output
GND
Agilent IPCMini Ion Pump Controller User Manual
Publicidad
