Eurocave Revelation Modo De Empleo página 34

6/ USING YOUR WINE CABINET FOR THE FIRST TIME
1. Connection and starting up
Wait 48 hours before plugging in your wine cabinet. To switch it on, press
and hold down button
Have your plug checked (presence of fuses, amps and 30 mA
circuit breaker. Fuse of 10A for one unit, 15A for two and 25A
for three. Use of multi-socket plugs is not recommended if
it does not respect above electrical data as well. Do not plug several
cabinet into a multi-socket.
II-A. Description (1-temperature model
A B C
P
A
Lighting mode
B
Open door alarm
C
Temperature zone
D
Sensor fault alarm
E
Temperature alarm
F
Charcoal filter alarm
G
Confirmation and setting access key
H
Setting and selection keys
II-B. Temperature setting
Press and hold down the
1
Press and hold down the
The display will start to flash
2
Press the or
3
16
Press the button to confirm
GB
for 5 seconds.
D E F
O N M L
key for 5 seconds to start up.
5 sec.
key for approximately 5 seconds.
keys to set the desired temperature
V-REVEL-S, V-REVEL-L
G H I
K J
I
Lighting mode confirmation and access key
J
Charcoal filter meter access key
K
Standby key
L
Humidity level alarm
M
Relative humidity level display
N
Heater in-use light
O
Compressor in-use light
P
Temperature display
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
•
The default setting is 12°C / 54°F (ideal maturing temperature).
However, you can set the temperature from 5 to 20 °C / 41 to 68°F.
•
Recommended temperature setting range for maturing wine:
10 - 14 °C / 50 - 57°F.
N.B.: to function correctly, your cabinet must be placed in a room with a
temperature of 0 - 35 °C / 32 - 95°F.
)
The tactile keys are very sensitive.
There is no need to apply force, only a
light touch is required to register the
command.
Remember to remove your finger from
the panel between each press.