Arktic 233207 Manual Del Usuario página 8

• Do not use hard utensils on the glass surface. Do not use wa-
GB
ter jets or steam cleaners during cleaning, do not immerse
the whole appliance in water as the parts will get wet and
electric shock might be resulted.
• Do not place articles on top of the appliance. Do not place ob-
jects with open sources of fire (e.g. candles) on top or beside
the appliance. Do not place objects filled with water (e.g. vas-
es) on or near the appliance.
• Never cover the appliance during use. This may cause a fire
hazard.
• Do not wash the appliance with water. Washing can cause
leakages and increase the risk of electric shock.
• Do not make any additional openings on the appliance. Do not
install any gadgets in the appliance.
• Do not overload the racks inside to avoid damage. Max. load-
ing of each rack is about 8kg.
• Do not attempt to climb up to the top of the appliance.
Installing the appliance
• The appliance should not be tipped over an angle of 45°. After
installing the appliance, wait for 2 hours before connecting it
to the electrical power supply. The same applies if the appli-
ance is moved at a later date.
• The appliance must always be installed in a dry environment.
• When installing, leave at least 20 cm clearance to the rear
and to the left and right for adequate ventilation. Leaving less
room for ventilation may affect the efficiency.
• We strongly recommend to install the appliance in a place with
good natural ventilation to increase ventilation properties.
Electrical components and other dangers
• No other appliances should be plugged into the same socket
as with this appliance.
• Do not place any dangerous products, such as fuel, alcohol,
paint, flammable or explosives, etc. inside or near the appli-
ance as it may result a fire hazard.
• Do not store any medications in the appliance.
• Wait about 5 minutes before switch on the appliance again af-
ter the appliance has been switched off or unplugged from the
electrical power supply.
• Do not wash the appliance with water. Washing can cause
leakage and increase the risk of electric shock. No any parts/
accessories can be under dishwasher.
Intended use
• This appliance is designed for short-time storage of cake at a
lower temperature for display to the customer. Any other use
may lead to damage of the appliance or personal injury.
• This appliance is designed for use in restaurants, canteens,
and commercial enterprises such as bakeries, supermarkets,
etc.
• This appliance is designed for commercial use.
• This appliance is intended for indoor use.
• Operating the appliance for any other purpose shall be
deemed a misuse of the device. The user shall be solely liable
for improper use of the device.
Grounding installation
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
8
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connections
must be properly installed and grounded.
Main parts of the product
(Fig.1 on page 3)
1. Glass door
2. Air suction
3. Ventilation holes
4. Air outlet
5. Rack
Control panel
(Fig.2 on page 3)
Diode Mode Meaning
on compressor enabled
flash anti short cycle delay enabled (AC
parametr)
on defrosting in progress
flash dripping in progress
°C
on measurment unit
flash programming mode
°F
on measurment unit
flash programming mode
Circuit diagram
(Fig.3 on page 4)
M1 – Fans for Evap. & Cond.
M2 – Fans for Compressor
ST – Temperature Sensor
D – DixzII XR02CX
S1 – Light Switch
S2 – Compressor Switch
L – LED Light
MC – Compressor
Preparation before use
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged and with
all accessories. In case of incomplete delivery and damages.
Please contact supplier immediately. Do not use the appliance.
• Clean the appliance before use (See ==> Cleaning & Mainte-
nance).
• Place all the racks inside the appliance.
• Keep the packaging if you intend to store your appliance in the
future.
Note: Due to manufacturing residues, the appliance may emit
a slight odor in the first few cycles. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
• Connect the power plug with a suitable electrical outlet.
Switch on the appliance. Leaving the appliance for running
some hours to reach the cooling temperature before placing
the beverage or food inside the appliance.