Publicidad
Idiomas disponibles
Idiomas disponibles
• See the set point
1. Push and immediately release the SET key, the set point will
be showed;
2. Push and immediately release the SET key or wait about 5s to
return to normal visualization.
• Change the setpoint
1. Push the SET key for more than 2 seconds to change the Set
point value;
2. The value of the set point will be displayed and the "ºC" or
"ºF" LED starts blinking;
3. To change the Set value push the or arrows.
4. To memories the new set point value push the SET key again
or wait 10s.
• Manual defrost
Push the DEF
key for more than 2 seconds and a manual
defrost will start.
• Change a parameter value
To change the parameter's value operate as follows:
1. Enter the Programming mode by pressing the SET +
for 3s ("ºC" or "ºF" LED starts blinking).
2. Select the required parameter. Press the SET key to display
its value.
3. Use
or
to change its value.
4. Press "SET" to store the new value and move to the following
parameter.
To exit: Press SET +
or wait 15s without pressing a key.
NOTE: the set value will be stored automatically after 15 sec-
onds.
• Keys combination
+
- to lock or unlock the keyboard
SET +
- to enter in programming mode
SET +
- to return to room temperature display
Cleaning & maintenance
ATTENTION! Always disconnect the appliance from the elec-
trical mains and cool down before storage, cleaning & main-
tenance.
Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
Cleaning
• The exterior and interior surfaces can be cleaned with a damp
cloth and a little detergent.
• Racks can be removed and washed in water.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water.
• No any parts can be cleaned in the dishwasher.
• Clean the appliance regularly.
Parts
All accessories
such as racks, rack
holders, etc.
External glass
surfaces
Interior glass
surfaces
Glass door
key
Maintenance
• Check the operation of the appliance regularly to prevent
problems that can cause serious accidents.
• As soon as you feel the appliance isn't working correctly or
there is a problem, stop using the appliance, shut it off and
contact the supplier.
Putting the appliance out of reach for a long period of time
• ATTENTION! Always unplug the appliance from the electrical
power outlet.
• Remove all the food and beverage inside the appliance.
• Clean the appliance as described in Cleaning. (See ==> Clean-
ing).
• Store the appliance in a cool, clean place and keep out of
reach of the children.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
How to clean
Remark
Soak in warm, soapy
Dry all parts well
water for about 10
at last.
to 20 minutes.
Rinse under running
water thoroughly.
Wipe clean with a
soft cloth and a little
neutral detergent.
Make sure no water
or moisture enters
inside the of the
appliance.
Remove any food
deposits
Wipe clean with
a soft cloth and a
little mild detergent.
Make sure no water
or moisture enters
inside the of the
appliance.
GB
9
Publicidad
