Design And Function; Short Description; Scope Of Delivery; Transport, Packaging And Storage - WIKA HP-2 Manual De Instrucciones

4. Design and function / 5. Transport, packaging and ...

4. Design and function

4.1

Short description

The prevailing pressure is measured at the sensor element through the deformation of a
EN
diaphragm. By supplying power, this deformation of the diaphragm is converted into an
electrical signal. The output signal from the pressure sensor is amplified and standard-
ised.
4.2

Scope of delivery

Cross-check scope of delivery with delivery note.

5. Transport, packaging and storage

5.1 Transport
Check the pressure sensor for any damage that may have been caused during transpor-
tation.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
5.3 Storage
Permissible conditions at the place of storage:
see chapter 3 "Specifications"
Store the pressure sensor in its original packaging in a location that fulfils the conditions
listed above.
WARNING!
Before storing the instrument (following operation), remove any residual
media. This is of particular importance if the medium is hazardous to health,
e.g. caustic, toxic, carcinogenic, radioactive, etc.
10 WIKA operating instructions pressure sensor, model HP-2