ABB TTF300 Instrucciones Para La Puesta En Funcionamiento página 46

Safety
1.6 Safety information for electrical installation
o
• The electrical connection may only be made by authorized specialist personnel and in
accordance with the electrical circuit diagrams.
• The electrical connection information in the manual must be observed; otherwise, the type of
electrical protection may be adversely affected.
• Safe isolation of electrical circuits which are dangerous if touched is only guaranteed if the
connected devices satisfy the requirements of DIN EN 61140 (VDE 0140 Part 1) (basic
requirements for safe isolation).
• To ensure safe isolation, install supply lines so that they are separate from electrical circuits
which are dangerous if touched, or implement additional isolation measures for them.
1.7 Safety information for commissioning
The transmitter is immediately ready for operation after mounting and installation of the
connections. The parameters are set at the factory.
The connected lines must be checked for firm seating. Only firmly seated lines ensure full
functionality.
1.8 Operating safety information
Before switching on, ensure compliance with the ambient conditions specified in the
"Specifications" chapter or data sheet and that the power supply voltage corresponds to the
voltage of the transmitter.
If you suspect that safe operation is no longer possible, take the unit out of operation and
secure it against unintended startup.
1.9 Returning devices
Use the original packaging or suitably secure shipping containers if you need to return the
device for repair or recalibration purposes. Fill out the return form (see the Appendix) and
include this with the device.
According to EC guidelines for hazardous materials, the owner of hazardous waste is
responsible for its disposal or must observe the following regulations for shipping purposes:
All devices delivered to ABB Automation Products GmbH must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Please
Please contact Customer Center Service acc. to page 1 for nearest service location.
8 - EN TTF300 CI/TTF300-X1