Publicidad
Idiomas disponibles
Idiomas disponibles
During normal saw operation, the temperature of
the chain increases. The drive links of a correctly
tensioned warm chain will hang approximately 1/16
in. (1.58 mm) out of the bar groove.
1/16 in. (1.58 mm)
WARNING
A slack chain may jump off and cause serious or
even fatal injury.
CAUTION
Wear protective gloves if you touch the chain, bar or
areas around the chain.
1.
Switch off the chainsaw and engage the chain
brake.
2.
Remove the battery pack.
3.
Loosen the chain cover nuts (15) with the wrench
(11).
It is not necessary to remove the chain cover to
adjust the chain tension.
4.
Hold the bar nose up and turn the chain
adjustment screw clockwise to increase the chain
tension, or turn counterclockwise to decrease the
chain tension.
English
NOTE
NOTE
5.
Pull the chain in the middle of the guide bar at the
bottom away from the bar, the gap between the
chain guide and the guide bar should be between
3 mm and 6 mm.
6.
When the chain is at the wanted tension, tighten
the lock nuts.
10.2
SHARPEN THE CUTTERS
Sharpen the cutters if chain does not go into wood
easily.
We recommend that a service center, which has
an electric sharpener, perform important sharpening
work.
1.
Tensioning chain.
2.
Sharpen the cutters corner with a 5/32 in. (4 mm)
diameter round file .
3.
Sharpen the top plate, side plate and depth
gauge with a flat file.
13
3-6 mm
NOTE
EN
Publicidad
