Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Put the oil into the oil tank. Be careful not to let
the oil spill from the opening. Wipe off any excess
oil.
5.
Monitor the oil window (7) to make sure that no
dirt gets into the oil tank while you add the oil.
6.
Put the oil cap on.
7.
Turn the oil cap clockwise and press the tab down
to close.
8.
The whole oil tank will last for approximately 20-
40 minutes.
IMPORTANT
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
8.3
ASSEMBLE THE GUIDE BAR AND THE
CHAIN
1.
Switch off the chainsaw and engage the chain
brake.
2.
Remove the battery.
3.
Remove the chain cover nuts with the wrench
(11).
4.
Remove the chain cover (14).
5.
Put the chain drive links (21) into the bar groove
(20).
6.
Put the chain cutters (22) in the direction of the
chain operation.
English
7.
Ensure the chain is put on in the correct direction
(do not assemble with the cutters backwards).
8.
Put the chain in position and make sure that the
loop is behind the guide bar.
9.
Hold the chain and bar.
10. Put the chain loop around the sprocket (16).
11. Make sure the chain tension pin hole (19) on the
guide bar fits correctly with the bolt (17).
12. Install the chain cover.
13. Tighten the chain. Refer to Adjust the chain
tension.
14. Tighten the nuts when the chain is correctly
tensioned.
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after
the first use, examine the tension and tighten the
chain if necessary.
9
NOTE
EN
Publicidad
