Broan best KEX273 Manual Del Usuario página 9

CONNECT DUCTWORK
1. Adjust the width of the flue mounting
bracket to equal the inside width of
decorative flue. Insert and tighten mounting
screws to hold bracket width. Use mounting
screws (4,8x38mm) and wall anchors to
secure flue mounting bracket to the ceiling
as shown.
2. Use 8" round metal duct to connect the
discharge collar on the hood to the
ductwork above.
3. Use duct tape to make all joints secure
and air tight.
4. Remove the 2 screws securing the flues.
5. Carefully place the lower decorative flue
into the recessed area of the range hood
top.
6. Extend the upper flue to the ceiling and
secure with the two mounting screws
(3,9x9,5mm).
DECORATIVE
FLUE
DUCT
TAPE
8" ROUND
METAL DUCT
REMOVE THE 2
SCREWS SECURING
THE FLUES
- 9 -
FLUE MOUNTING BRACKET
MOUNTING
SCREWS
MOUNTING SCREWS
(4,8x38mm)
9-1/8"
9-1/8"
FASTEN FLUE TO
BRACKET WITH MOUNTING
SCREWS (3,9 x 9,5mm)