Assembly Instructions Pump In Style Original Breastpump; Important - Medela Pump In Style Original Instrucciones De Uso

Assembly Instructions - Pump In Style Original
Breastpump
1. Make sure breastshield and connector are
securely attached.
2. Snap membranes onto valves until membranes
lie completely flat.
*Be sure to separate membranes & valve heads when
cleaning and completely dry prior to assembly.
3. Push assembled valves & membranes
onto breastshield connectors.
4. Screw containers into
breastshield connectors.
5. Insert hard adapter ends of tubing into
openings in breastshield connectors.
6. Insert other ends of tubing onto ports on
diaphragm cap. To remove tubing, pull
straight out of tubing ports; do not wiggle
tubing or pull at an angle.
6
7. If single pumping: insert port cap into the
unused port.
8. If double pumping: push port cap onto
center post.
9. Plug the metal fitting on end of transformer or
Battery Pak cord into power jack on breast-
pump. Plug the transformer into a standard
electrical outlet.
10. Center breastshields over your nipples.
IMPORTANT: Do not tilt or overfill
containers when pumping.

IMPORTANT

Take care not to kink tubing(s)
while pumping.
11. Switch on Pump In Style Original and start
pumping. Adjust speed and vacuum for your
comfort.
Tip: Once you are finished pumping, unplug tubing from
back of breastshield prior to setting down bottles.
7