Pump In Style Original Battery Pak; Battery Insertion; Battery Removal - Medela Pump In Style Original Instrucciones De Uso

Assembly Instructions for Manual Pumping with
Pump In Style Original
Manual pump (#8007124) sold separately from
Pump in Style Original Breastpump.
Note: Follow steps 1-4 on page 6.
5. Slip rubber seal onto piston until it snaps into
place—the larger side faces the handle. To
ensure proper seal, hold rubber seal firmly
and twist piston.
6. Slide piston into cylinder.
7. Screw cylinder into back of breastshield
connector.
8. Set vacuum regulator ring to "MIN." Adjust
for comfort once pumping begins.
9. Center breastshield over your nipple, and
begin pumping.
IMPORTANT
Do not overfill or tilt the containers
when pumping.
8

Pump In Style Original Battery Pak

Instructions
The Pump In Style Original Battery Pak is intended for
use with the Pump In Style Original ONLY. The Battery
Pak uses 8 AA alkaline batteries, or for more consistent
pump performance, rechargeable batteries. Each set
of batteries will provide approximately 3 hours of
pumping time. It is recommended that batteries be
replaced or recharged between the 10th and 12th
pumping session.

Battery Insertion

Slide off battery covers. Place the NEGATIVE (-)
end of the battery against the front of the spring.
Push the battery in and down in one motion until the
battery snaps into place. The POSITIVE (+) end of
the battery should be near the positive sign on the
Battery Pak. NOTE: If the battery is inserted in the
opposite direction, the battery may not function
correctly. Four batteries must be inserted on each side of the Pak.
Replace battery covers.

Battery Removal

Slide off battery covers. Insert a BLUNT, NON-METALLIC tool into the
removal slot on either side of the Battery Pak. Gently pry the battery out.
Replace battery covers.
9