Accessories - Triton TA 1200BS Instrucciones De Uso

USING THE INVERSION CLAMP SET
• The Inversion Clamp Set enables use of the Triton 76mm Belt Sander in
an inverted position. The sander must only be used in an inverted position
when clamped securely to a suitable structure with a solid, flat work
surface
1. Push the Auxiliary Handle (1) fully forward
2. Invert the machine and place on a solid,
flat work surface. Ensure the underside
is flat and there is sufficient access to
accommodate the length of the G clamp
bases
3. Insert the G clamps fully into the fixing
positions on the sander. Ensure the vertical
threaded section of each G clamp is tight up
against the edge of the work surface
4. Tighten the butterfly nuts so that the sander is securely clamped to the
work surface
5. Fit the Backstop (17) in position using the Backstop Screw (16)
6. The backstop may be fixed in a raised position or almost level with the
sanding belt. Ensure that the backstop is not in contact with the sanding
belt
7. Fit dust extraction system or dust bag
8. Turn on the sander and use the lock-on button to keep the sander running
9. Check solidity of fixing and alignment of sanding belt whilst running the
sander. If necessary, turn off and refix the sander
WARNING: DO NOT use the sander inverted unless it is securely clamped to
the work surface.

ACCESSORIES

• A full range of different grit sanding belts and accessories is available from
your Triton stockist. Spare parts can be obtained from toolsparesonline.com
FITTING THE OPTIONAL SANDING FRAME (TBSIS)
• The sanding frame helps to control depth of cut
and prevents tilting and gouging
1. Use the Inversion Clamps (15) to secure the
belt sander on a solid, flat, level work surface
in an inverted position
2. Place the Sanding Frame (18) over the sander
so that, with the smooth surface of the frame
uppermost, the fixing positions on the frame
correspond with the fixing positions on the
sander
3. Insert the Frame Locking Knobs (20)
on the side where there are two fixing
positions then tighten to secure the
frame, but allow for a small amount of
movement
4. Insert the Depth Plate Locking Knob
(19) in the single fixing position (on the
opposite side to the frame locking knobs).
Align the depth calibrations with the
scale pointer at the position required
NOTE: For minimum sanding depth, align
with calibration furthest from the frame
surface (see above)
5. Use a level to check the frame is
horizontal, then tighten the locking knobs
fully to secure the frame ready for use
USING THE SANDING FRAME
• We recommend that you begin by sanding against the grain
• Start the sander facing at 10 or 11 o'clock, and move it back and forth
across the workpiece slowly. Finish by sanding parallel to the grain
GB
Operation / Accessories 7