Maintenance; Disposal - Triton TA 1200BS Instrucciones De Uso

MAINTENANCE

WARNING: Always disconnect from the power supply before carrying out any
inspection, maintenance or cleaning.
GENERAL INSPECTION
• Regularly check that all the fixing screws are tight. They may vibrate loose
over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear.
Repairs should be carried out by an authorised Triton service centre. This
advice also applies to extension cords used with this tool
CLEANING
• Keep your tool clean at all times. Dirt and dust will cause internal parts
to wear quickly, and shorten the device's service life. Clean the body of
your machine with a soft brush, or dry cloth. If available, use clean, dry,
compressed air to blow through the ventilation holes (where applicable)
LUBRICATION
• Slightly lubricate all moving parts at regular intervals with a suitable spray
lubricant

DISPOSAL

Always adhere to national regulations when disposing of power tools that are
no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
GB
8 Maintenance / Dispisal
CHANGING THE DRIVE BELT
Note: A spare drive belt is supplied with the sander. Further replacements
and other spare parts are available from your Triton stockist or from
toolsparesonline.com.
1. Using a Phillips screwdriver, remove the screw holding the Drive Belt Cover
(5) in place
2. Remove the worn belt by easing it off the bottom larger drive pulley, and
then lift away
3. Clean all dust and debris away
4. Place new drive belt over the top drive pulley and push onto the larger
pulley, then rotate the belt until it is on both pulleys and located in the
grooves of each pulley
5. Place the drive belt cover back on and screw the fixing screw tight
STORAGE
• Store this tool carefully in a secure, dry place out of the reach of children