Janome 385.8080200 Manual De Instrucciones página 58

[] Raise t heneedle a nd foot. P lace theautomatic
buttonhole foot w ithitspinjustunder thegroove o f
thefootholder. Lower thepresser bartoattach t he
foot.
O Groove
(_)Pin
[] Pull t hebutton holder open totheback (A), a nd
place thebutton init.Push thebutton holder
closed ( B)tohold thebutton.
(_)Button h older
NOTE:
Ifthebutton isextremely thick, m ake a test
buttonhole, Ifitisdifficult tofitthebutton through t he
testbuttonhole, lengthen thebuttonl'iole bypulling
thebutton holder back tocreate a gap.
(_)Gap
[] Pull t hebuttonhole lever d ownward asfarasitwill
go.
Q Buttonhole lever
[] Raise thebuttonhole footand draw theneedle
thread t otheleftthrough t hehole onthefoot.
Place thefabric under t hefootandlower t he
needle a tthestarting p oint b yturning t he
handwheei. Then lower t hefoot.
(_ Buttonhole mark
O Starting p oint
(_) Slider
O Nogap
@Spring h older
O Sewing g ap
NOTE:
Make sure there is no gap between the slider and
spring holder, otherwise the left and right length of
the buttonhole will be different.
[]
[]
[]
[]
A
Q
@
46 i_