Inserting The Bobbin - Janome 385.8080200 Manual De Instrucciones

inserting the bobbin
[] Placethe bobbinin the bobbinholderwith the
thread runningcounter-clockwise.
End of the thread
Bobbinholder
[] Guide the thread into the slot A on the front side
of the bobbin holder. Draw the thread to the left
sliding it between the tension spring blades.
(_) Slot A
[] Continue to draw the thread lightly through the
tension blades until it slips into slot B.
(_) Tension blades
(_ Slot B
[] Draw the thread to the back.
The bobbin should turn counterclockwise when
pulling the thread.
[] Pull out about 10 cm (4") of thread and attach the
hook cover.
(_ Bobbin thread
(_ Align left edge of the hook cover.
[]
[]
[]
[]
[]
22