Cleaning Hook Race And Feed Dog - Janome 385.8080200 Manual De Instrucciones

Cleaning Hook Race and Feed Dog r _,
WARNING;
Raise thepresser foot and needle, and then unplug
the machine.
DO NOT dismantle the machine other than as
explained in this section.
[] Remove the needle and presser foot.
0 Screwdriver
(_ Setscrew
(_) Needle plate
[] Remove the setscrew and needle plate.
[] Take out the bobbin and bobbin holder.
[] Clean the bobbin holder with the lint brush and soft
dry cloth.
(_ Bobbin holder
[] Brush out dust and lint from the feed dog and clean
the hook race with the lint brush.
[] Wipe inside of the hook race with a dry cloth.
NOTE: I
You may use vacuum cleaner.
[] Replacing Bobbin Holder and Needle Plate
[] Insert the bobbin holder.
Make sure to fit the knob next to the stopper in the
hook race.
_) Guide pins
(_) Knob
(_ Stopper
[] Insert the bobbin and attach the needle plate
aligning the holes with the guide pins.
(_ Holes
[] Tighten the setscrew firmly.
(_ Setscrew
NOTE:
After cleaning the machine, attach the needle and
presser foot.
[]
[]
[]
[]
78