Problems And Warning Signals - Janome 385.8080200 Manual De Instrucciones

PROBLEMS AND WARNING SIGNALS
When beep sounds and the LED display shows warning signal, follow the guidance below to deal with.
Visual signal
f
LED Cause and Action
rc
The foot control has been disconnected while sewing.
Turn OFF the power and connect the foot control.
A button is pressed when the machine halts due to the overload.
Wait for at least 15 seconds to recover.
If thread jamming causes overload, remove the tangled threads.
The Up (+) or Down (-) key is pressed after buttonhole is finished but the foot is not
raised.
Raise the foot.
Do not use the automatic buttonhole foot to sew any other pattern than buttonhole or
darning.
The machine is out of order.
Contact Sears Parts & Repair Center below.
1-800-488-1222 (USA only)
1-800-533-6937 (Canada only)
Audible Signal
BEEP Beep sounds when:
pip Normal operation
pip-pip-pip Invalid operation
pip-pip-peep Buttonhole is finished.
k. peep The machine is out of order.
8O