Publicidad
Idiomas disponibles
Idiomas disponibles
:
Tighten the wingnut clockwise.
:
Standing in the normal working
position, check the depth of cut
again and correct it if necessary.
FC 75
90°
Edging
:
Start the engine.
:
Start the cut at no less than half
throttle and continue cutting at full
throttle.
:
Hold and guide your edger so that
the blade is vertical.
:
Cut steadily so that the engine is not
lugged down – do not apply force.
:
Cut at a normal walking pace.
:
Do not push the blade into the
ground.
English / USA
1
:
Always walk forwards when cutting,
do not pull the unit towards you.
:
Edge at a steady pace to avoid
having to make several passes.
1 = Gunning sight for edger blade
15
Publicidad
