Publicidad
Idiomas disponibles
Idiomas disponibles
2
:
Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.
FC 75
Fitting the Edger Blade
1
1
:
Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
English / USA
5
6
4
2
3
:
Insert stop pin* or offset
screwdriver* (2) as far as possible in
the bore (3) – push lightly and rotate
it back and forth together with the
thrust washer (4) until the drive shaft
is blocked.
:
Fit combination wrench (5) on the
nut (6).
:
Loosen and remove the nut
clockwise (left-hand thread).
:
Remove the thrust washer.
*
see "Guide to Using this Manual"
17
Publicidad
