Publicidad
Idiomas disponibles
Idiomas disponibles
:
Put the unit on the ground:
It must rest securely on the engine
support and deflector.
Check that the cutting tool is not
touching the ground or any other
obstacles.
:
Make sure you have a firm footing.
:
Hold the unit with your left hand on
the control handle and press it down
firmly – your thumb should be
under the control handle.
Do not stand or kneel on the drive
tube! This could permanently
damage the drive tube.
FC 75
:
Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull.
Do not pull out the starter rope all
the way – it might break.
:
Do not let the starter grip snap
back – guide it slowly into the
housing so that the starter rope can
rewind properly.
:
Continue cranking until the engine
runs.
When engine begins to fire:
:
Move choke lever to e
:
Continue cranking.
As soon as engine runs:
:
Blip the throttle trigger –
the slide control moves to the run
position # – and the engine returns
to idling speed.
Make sure carburetor is correctly
adjusted – the cutting tool must not
rotate when the engine is idling.
Your power tool is ready for
operation.
English / USA
To shut down the engine:
:
Push the slide control in the
direction of the arrow (h ) to
STOP-O.
Other points to observe when
starting
At very low outside temperatures
As soon as engine runs:
:
Blip the throttle trigger to disengage
the starting throttle position –
the slide control moves to the run
position # – and the engine settles
down to idle speed.
:
Allow engine to warm up for a brief
period at part throttle.
If the engine does not start
If you did not move the choke lever to
e quickly enough after the engine
began to fire, the combustion chamber is
flooded.
:
Move the choke lever to e
:
Set the slide control, interlock lever
and throttle trigger to the starting
throttle position.
21
Publicidad
