Publicidad
support@nextlevelracing.com
A)
B)
25
A) Align the mounting holes on the Centre Pole Bracket with the mounting slots and inserts on the Centre Pole Mount.
B) Bolt through and secure with 2 x M8 Knobs and Washers & 1 x M8 Bolt, Ny-lock Nut and Washer.
A)
B)
26
A) Align the threaded inserts and slots on the HOTAS Angle Bracket with the mounting slots on the Centre Pole Bracket.
B) Bolt through and secure with 1 x M8 Bolt, 2 x M8 Shoulder Bolts, 1 x Washer and Flange Nut.
A)
B)
A) Install the Seat Bottom Cushion previously uninstalled in Step 24.
27
B) Align the mounting holes on the HOTAS Plate with the threaded inserts on the HOTAS Angle Bracket. Bolt
through and secure with 2 x M8 Bolts.
20
PARTS:
CENTRE POLE BRACKET ADJUSTMENT
• • 1 x Centre Pole Bracket
A)
• • 1 x M8 60mm Sockethead Bolt
• • 2 x M8 12mm Knobs
• • 3 x M8 Washers
• • 1 x M8 Ny-lock Nut
28
PARTS:
HOTAS ANGLE ADJUSTMENT
• • 1 x HOTAS Angle Bracket
A)
• • 1 xM8 55mm Sockethead Bolt
• • 2 x M8 Shoulder Bolts
• • 1 x M8 Washer
• • 1 x M8 Flange Nut
29
PARTS:
HOTAS BRACKET HEIGHT ADJUSTMENT
• • 1 x HOTAS Plate
Note: Ensure the
shoulder on the
Shoulder Bolt is
properly secured
• • 2 x M8 16mm Countersunk Bolts
in the slot to
avoid slipping.
30
B)
A) Loosen the Knobs securing the Centre Pole Bracket to the Centre Pole Mount.
B) Adjust to the desired angle and tighten the Knobs to secure.
B)
A) Loosen the Bolts securing the HOTAS Angle Bracket to the Centre Pole Bracket.
B) Adjust to the desired angle and tighten the Bolts to secure.
1
1
2
2
1) Loosen the Shoulder Bolt until the shoulder is exposed and free to move. Loosen the M8 Bolts to allow
movement. 2) Adjust to the desired height and tighten both the M8 Bolt and Shoulder Bolt to secure.
21
Video Instruction: bit.ly/nlrbuild
PARTS:
• • NIL
PARTS:
• • NIL
PARTS:
• • NIL
Front View
Front View
Publicidad
