Publicidad
support@nextlevelracing.com
A)
B)
WARNING: Ensure you are
firmly holding the Recliner
before lifting the adjustment
lever to avoid injury.
07
A) Uninstall the pre-installed Bolts on the Seat Backrest.
B) Adjust the Seat Recliners on the Seat Bottom to an upright position.
A)
B)
08
A) Align the Seat Backrest threaded inserts with mounting holes on the Seat Recliners.
B) Bolt through and secure with the Bolts previously uninstalled in Step 07a.
A)
B)
09
A) Slide the seat forward and align the rear Seat Slider mounting holes on the Seat Assembly with the threaded inserts on the H Frame.
B) Bolt through and secure with 2 x M8 Bolts and Washers.
PARTS:
• • 1 x Seat Bottom
• • 1 x Seat Backrest
PARTS:
• • Use Pre-installed Hardware
PARTS:
• • 2 x M8 16mm Sockethead Bolts
• • 2 x M8 Washers
14
A)
B)
10
A) Slide the Flight Seat all the way back to access the front mounting holes on the Seat Sliders.
B) Bolt through and secure with 2 x M8 Bolts and Washers.
A)
B)
11
A) Align the mounting holes on the Flight Arm with the threaded inserts on the Frame Member.
B) Bolt through and secure with 4 x M8 Bolts and Washers.
A)
B)
12
A) Align the mounting slots on the Telescoping Outer Arm with the threaded inserts on the Flight Arm.
B) Bolt through and secure with 4 x M8 Bolts and Washers.
15
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x M8 16mm Sockethead Bolts
• • 2 x M8 Washers
PARTS:
• • 1 x Flight Arm
• • 4 x M8 16mm Sockethead Bolts
• • 4 x M8 Washers
PARTS:
• • 1 x Telescoping Outer Arm
• • 4 x M8 16mm Sockethead Bolts
• • 4 x M8 Washers
Publicidad
