Mounting The Mowing Head - Stihl FS 100 RX Manual De Instrucciones

Preparations
: Lay your brushcutter on its back
with the gearhead facing upward
FS 100 RX
Blocking the Output Shaft
: Insert the stop pin* (2) or
screwdriver* (2) in the bore (3) in the
gearhead as far as stop, apply slight
pressure.
: Rotate nut or cutting tool on the
shaft (1) until the stop pin slips into
position and blocks the shaft.
After mounting the cutting tool,
remove the tool used to block the
shaft.
* Comes standard with the machine or
is available as special accessory –
see „Special Accessories"
English / USA

Mounting the Mowing Head

Keep instruction sheet for mowing head
in a safe place.
: Screw the
STIHL SuperCut 20-2,
STIHL AutoCut 25-2
STIHL TrimCut 30-2,
counterclockwise onto the shaft (1)
as far as stop.
: Block the output shaft.
: Tighten down the mowing head.
Remove the tool used to block the
shaft.
15