Temporarily Stopping The Sewing Machine; Performing Re-Sewing - JUKI MEB-3200 Manual De Instrucciones

(3) Temporarily stopping the sewing machine

(4) Performing re-sewing

Sewing can be performed without making the cloth open operation.
■ How to stop the sewing machine
1) Press temporary stop switch
2) The sewing machine stops and "Er 10" is displayed.
■ How to re-start
1) Press [RESET ] key
displayed and the error is released.
2) Re-start the sewing machine using the start switch,
or press [FORWARD
key and the feed mechanism travels forward/
backward stitch by stitch.
Further, press [RESET
sewing machine to the sewing start position.
Operation of [FORWARD
[BACK ] key or [RESET
perform thread trimming.
When temporarily stopping the sewing machine
during sewing and returning the sewing
machine to the start position with [RESET
key, draw out needle thread, cut the thread
with scissors or the like and perform the work.
The work can be performed without applying a
forced load to needle or sewing product.
1) Make sure that sewing LED
When the LED lights up, press [READY
to make it go out.
2) Press [OPEN ] key
LED .
3) Press [READY ] key
retrievel and the right and left presser plates
open. The cloth setting position becomes the
knife actuating position.
4) The sewing can be performed with the presser
switch and the start switch.
Cloth open ON/OFF operation is not performed.
5) To release this setting, press [READY
to make the sewing LED go out, then press [OPEN
] key to make cloth open LED
When the cloth cutting knife is not operated,
prohibit the knife operation with [KNIFE ON/
OFF ] key .
.
while "Er 10" is being
] key or [BACK ]
] key to return the
] key,
] key cannot
]
goes out.
] key
to light up cloth open
to perform the origin
] key
go out.
17