Setting The Pattern Data Of Cloth Cutting Knife Pressing Amount - JUKI MEB-3200 Manual De Instrucciones

(8) Setting the pattern data of cloth cutting knife pressing amount

The cloth cutting knife pressing amount can be set to the pattern data, and even when the knife holder is
replaced, the knife adjustment is not performed. The setting can be completed by changing the pattern No.
only.
The knife holder No. 0 to 9 up to 10 kinds are set to the pattern data No. 28 and the knife pressing amounts
can be set to each of knife holder Nos.
1) Set memory switch No. 40 to "1".
■ Adjusting the knife pressing amount
For the caution regarding adjusting the cloth cutting knife pressure, refer to (2) Adjusting the cloth
cutting knife pressure on page 27.
■ Pattern data setting procedure
44
1) Pressing [ADJUST
2) The knife holder No. is displayed in 2-digit LED and the knife pressing
amount which has been set to each knife holder No. is displayed in
4-digit LED .
3) Press [READY ] key
feed base and the cloth cutting knife perform origin retrieval.
4) The knife holder No. desired to be set can be set with [LEFT
or [LEFT ] key
5) The knife pressing amount in terms of the knife holder No. displayed in
the 2-digit LED can be set with [RIGHT
. The setting range is -100 to 300. The more the number is, the higher
the cloth cutting knife pressure becomes.
6) Lower the presser with the presser switch and press the start switch to
actuate the knife. The knife holder No. can be set again with the presser
raised using [LEFT
pressing amount can be set again using [RIGHT
] key .
7) Press [ADJUST
adjustment mode ends.
The set value is stored in memory when the knife is actuated by
the start switch or [ADJUST
the knife holder No. without performing either operation, or turning
OFF the power, the setting is not stored in memory.
The knife holder No. to which the knife pressing
amount has been set is set.
For the data setting procedure, refer to Compensation
of the data on page 31.
1) Press [LEFT
28.
2) Press [RIGHT
No. 0 to 9 can be set.
] key , turn ON the power.
to light up the sewing LED. At this time, the
. The setting range is 0 to 9.
] key or [LEFT
] key after completion of setting and the knife
] key
] key or [LEFT
] key or [RIGHT
] key
] key or [RIGHT
] key . In addition, the
] key or [RIGHT
is pressed. When changing
] key to display data No.
] key to set the data
] key