Attaching The Needle - JUKI MEB-3200 Manual De Instrucciones

■ Lubricating the needle bar and cam components
Lubricate the components at the time of delivery or after an extended period of disuse.

(2) Attaching the needle

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
With thread
Standard
tension disk (OP)
1) Loosen setscrews
2) Apply one to two drops of oil to needle bar
bushing
3) Apply oil to the felts and the oil wicks in the face
plate section of the sewing machine.
4) Loosen setscrew
cover
5) Apply oil to the felts and the oil wicks in the
sewing machine arm.
6) After lubrication, install face plate
face cover
TThe correct direction of the needle is that needle
thread guide
of the needle.
Put needle as
far as it goes.
and remove face plate
and needle bar .
and remove the upper face
.
Remove the cover with care since the air
tube is connected with the cord.
.
Be careful not to allow the cords to be
caught in the machine.
faces the opposite side of groove
1. Use the most suitable size of needle in
accordance with the kind and thickness
of thread and kind of material to be used.
2. When changing the size of needle, be
sure to adjust the clearance between
the needle and the looper. (Refer to (3)
Clearance between the needle and the
looper, p.47.)
.
and upper
9