Installation; Safety Functions Module Installation - WEG CFW500-SFY2 Instrucciones Y Manual De Seguridad

2 INSTALLATION

The inverter must be installed according to the instructions of the CFW500 user's manual.
Table 2.1 on page 11 presents the technical data related to the CFW500-SFY2 safety functions
module.
Dimensions
Mass
Enclosure
Operating Temperature
Storage Temperature
Air Relative Humidity
Maximum Altitude
Pollution Degree
ATTENTION!
If pollution degree 2 cannot be guaranteed, IP54 protection class must be used.

2.1 SAFETY FUNCTIONS MODULE INSTALLATION

For the proper installation of the safety functions module, follow the steps below:
Step 1: With the CFW500 de-energized, remove the STO jumper connector locate on top of
the frequency inverter according to
Step 2: Fit and press the CFW500-SFY2 to be installed on top of the frequency inverter according
to Figure A.1 on page 107
Step 3: Follow the energization and start-up procedure described in the CFW500 user's manual.
Step 4: Check whether parameter P0028 is showing value 1 (P0028 = 1). If this is not the case,
check the connection of the CFW500-SFY2 module on top of the frequency inverter and repeat
the steps above.
NOTE!
Either the STO jumper connector or the CFW500-SFY2 safety functions module
must be installed on top of the frequency inverter. Otherwise, the fault message
"F0086" will be displayed by the frequency inverter during power-on.
Table 2.1: CFW500-SFY2 technical data
Figure A.3 on page 108
56 g
IP20
-10 °C ... 40 °C (14 °F ... 104 °F)
-25 °C ... 60 °C (-13 °F ... 140 °F)
5 % ... 95 % non-condensing
Up to 2000 m: nominal conditions.
From 2000 m to 4000 m: voltage derating of 1.1 % for each 100 m above
2000 m
2 (according to EN 50178 and UL 508C), with non-conductive pollution
Condensation must not originate conduction through the accumulated
residues
Figure A.1 on page 107
(b).
in Appendix A
(a).
Installation
CFW500 | 11