Connect The Ph Electrodes; Meter Stand For Adjusting View Angle; Attached Quick Guide - OHAUS STARTER 3100 Manual De Instrucciones

STARTER 3100 Bench pH Meter
2.4

Connect the pH electrodes

There are 3 sockets for electrode. "pH" socket (BNC); "TEMP." Socket (Cinch) and "REF" Socket
(2mm banana).
For ST310 electrode connect to the BNC and Cinch socket. For 2-in-1 pH electrode (e.g. ST210)
you only need to connect the BNC.
REF socket is for separate reference electrode. (e.g.STREF1)
2.5

Meter stand for adjusting view angle

One unique design of the STARTER 3100 is the meter stand, which can be used to adjust the view
angle of the display in case of working on high table.
2.6

Attached quick guide

Another unique design of the STARTER 3100 is the attached quick guide, the quick guide is
attached into the bottom housing of the meter.
EN 7
-