JVC DT-E17L4G Manual De Instrucciones página 20

Menu Configuration (cont.)
Picture Sub Adjust
Configure the standard level of image adjustment.
Item To do
Contrast* 1 Adjust the standard level for the contrast adjusted with the CONTRAST knob on the front
panel.
Bright* 1 Adjust the standard level for the brightness adjusted with the BRIGHT knob on the front
panel.
Chroma* 1 Adjust the standard level for the chroma adjusted with the CHROMA knob on the front panel. –20 to +20
Phase* * Adjust the standard level for the phase adjusted with the PHASE knob on the front panel.
1, 2
NTSC Setup Select the set-up level of the input NTSC signal.
Component Level Select the level of the analog component signal (480i and 576i only).
sub menu Display the sub menu which enables you to adjust the items in "Picture Sub Adjust" while viewing the actual picture.
reset Restore the default settings for all the items in "Picture Sub Adjust".
* 1 Memorized for each input.
* When "Component Phase" is set to "Disable," "Phase" cannot be adjusted if no NTSC signal is input.
2
White Balance Setting
Display the color temperature, and adjusts the drive level and cutoff point of each color (R/G/B).
Item To do
Color Temperature Select the color temperature. (Cannot be set/changed)
R Drive * Adjust the drive level of each color (red, green, and blue).
1
●
G Drive The maximum (Max) and minimum (Min) values vary depending on the input signal or
B Drive other settings.
R Cut Off * Adjust the cutoff point of each color (red, green, and blue).
1
●
G Cut Off The maximum (Max) and minimum (Min) values vary depending on the input signal or
B Cut Off other settings.
sub menu Display the sub menu which enables you to adjust the items in "White Balance Setting" while viewing the actual picture.
reset Restore the default settings for all the items in "White Balance Setting".
* 1 Memorized for each color temperature.
Remote Setting
Settings for the external control.
Item To do
Serial Type Select a terminal for external control in serial mode.
Parallel Type Select a control method of the MAKE/TRIGGER terminal.
Pin1
Pin2
Assign the control functions to the pins of the MAKE/TRIGGER terminal.
Pin3 • Assign a function to each pin terminal by selecting "Set" in "Parallel Type" mentioned
above.
Pin4
Pin5
Pin6 The functions are assigned for "Pin6" – "Pin8" and you cannot change the assignment of
these functions.
Pin7
Pin8
18
Setting value
–20 to +20
–20 to +20
–20 to +20
00 (compliant with 0 %
set-up signal), 7.5 (compliant
with 7.5 % set-up signal)
B75 (compliant with
BetacamVTR 7.5 % set-up
signal), B00 (compliant with
BetacamVTR 0 % set-up
signal), SMPTE (compliant
with M2VTR signals)
Setting value
9300K, 6500K, User
Min – 000 – Max
(in 1024 grades)
Min – 000 – Max
(in 1024 grades)
Setting value
RS232C, RS485
Make, Trigger, Set
☞ "Display" in "Functions
controlled by the Make/
Trigger system" on page 23
Tally
Enable
GND