Thermador Professional Serie Guia De Instalacion página 20

en-us Installation
Access the hood's wiring. Route the 30 ft. extension
2.
harness through the strain relief to the square mounting
clip until it clicks.
Route the 30 ft. extension harness through the cutout
3.
and connect the harness to the back of the remote
control bracket.
Press the bracket inside the cutout. Drill a ¼" (6 mm)
4.
tap hole through the bracket holes into the wall. Mount
the bracket to the wall using the four (4) screws
provided.
5.8 Duct cover extension (optional)
Optional duct cover extensions and telescoping extensions are used to fill the space between hood and ceiling. The
extensions are available for separate purchase.
Use chimney extensions for 8' (2.4 m) ceilings
¡
Hood model 6" extension
HPCN36WS CHMHP366W
HPCN48WS CHMHP486W
Installing the duct cover extension
Requirement: IMPORTANT: Secure the chimney wall
hood to the wall before installing the chimney extension.
→ Page 15
20
Hook up the wire harness connector inside the bracket
5.
to the terminal on the back side of the remote control.
Use either terminal.
Snap the remote control into the bracket.
6.
Use telescoping extensions for 10' (3 m) ceilings.
¡
Telescopic extension
CHMHP48TW (18"– 35")
CHMHP48XTW (42"–59")
CHMHP48TW (18"– 35")
CHMHP48XTW (42"–59")
Installation of the chimney hood should maintain a
1.
minimum height of 30" (762 mm) from the bottom of the
hood to the cooking surface. To determine placement of
the hood with a chimney extension, the height of the