Publicidad
Idiomas disponibles
Idiomas disponibles
5.1.2.4 ANOMALOUS CASES:
Anomalous cases which can occur during the following "AUTO", "R+", "R-", "R+TIMER",
"R-TIMER"
In case a value of Ravg or R+ or R-
higher than or equal to 5Ω but
lower
R+TIMER
detected, at the end of the test the
instrument emits a long sound
signal displays one screen similar to
the screen alongside.
SAVE
In case one of the following modes
AUTO, R+, R- and a Ravg or R+ or
R- higher than 99.9Ω was selected,
at the end of the test the instrument
emits a long sound signal and
displays the screen alongside.
Selected mode (in the picture the
mode
AUTO
example).
SAVE
If the terminal voltage is higher than
10V, the instrument does not carry
out the test and displays the screen
alongside for 5 seconds after which,
the instrument displays the screen
relative to the precedent selected test
mode LOWΩ under AUTO mode.
SAVE
than
99.9Ω
(9.99Ω
and
R-TIMER)
Selected mode (in the picture the mode AUTO
is indicated as example).
The tests can be stored pressing the SAVE key twice (according to
paragraph 0).
is
indicated
as
The tests can be stored pressing the SAVE key twice (according to
paragraph 0).
THIS RESULT CANNOT BE SAVED
CAL LOW
in
was
216
AUTO
CAL LOW
o> 99.9
- - -
AUTO
ATTENTION: value of R
high.
CAL LOW
o A
VOL
12
ATTENTION:
Ω
average value
o 5.75
of Ravg higher
Ω
than 5Ω.
5
mA
s
Only in case
the
R+TIMER
R-TIMER was
selected.
99.9Ω is the
Ω
maximum
value which
Ω
can
measured in
the
mA
AUTO
R+
mode.
or R+ or R- is too
avg
ATTENTION:
Ω
the test was
not made
Due to voltage
at the terminal
AG
ends.
mode
or
be
LOWΩ
or
or
R-
Publicidad
