Amprobe MEGATEST 1000 Manual Del Propietário página 9

4.1 CANCELLATION OF CALIBRATION PARAMETERS
To cancel calibration parameters
(and the
necessary
instrument with a resistance
higher than 5Ω (for example with
disconnected test leads). When a
cancellation is made the screen
on the right is displayed first,
followed by the screen below:
The screen on the right is
displayed for 2 seconds, after
which the instrument emits a long
sound signal and then displays
the default screen relative to the
LOWΩ test under AUTO mode.
symbol CAL) it
to recalibrate
Ω
LOW
is
o> 5
the
cal
Measuring
Ω
LOW
es
cal
8
Message >5Ω:
means that the
instrument detected
Ω
a resistance higher
than 5Ω therefore it
will proceed with
Reset procedure.
Message rES:
means that the
instrument
cancelled the
calibration
parameter
(RESET) of the
calibration
parameters