Publicidad
Idiomas disponibles
Idiomas disponibles
Fan On/Off and Speed Reduction
•
Press this icon once to turn on the fan motor at speed 1. All icons will be white and the light icon will be
red if already in use.
•
If the motor is on speed 1, pressing and holding this icon for two seconds will turn off the fan motor.
•
As above, the light control is independent of this operation.
•
If the motor is higher than speed 1, this will reduce the fan speed with each press of the icon.
LED Display
•
Displays the extraction mode during set up and the motor speeds from 1-3.
Speed Increase
•
Press this icon once to turn on the fan motor at full power, and 3 will display.
•
If the motor is already on speed 1-2, each press of this icon will increase the fan speed accordingly.
•
If you press and hold the icon for two seconds, the fan speed will increase to full power and 3 will
display.
Setting the Timer
•
When the fan motor is on and the Timer icon is pressed, it will be red and the current speed in the
display will start to flash and continue until the timer cycle has completed.
•
The chosen speed level will remain in use for five minutes before dropping down to the next lowest
speed. This speed will remain in operation for two minutes before dropping down again. This will be
repeated every two minutes unless the speed is already at level 1 and then the fan will turn off. If the
light is already on, this will also be turned off.
•
Pressing the Speed Reduction icon
restart the countdown process again with a five minute cycle.
•
If the Timer icon is pressed again during a current timer program, the cycle will be cancelled, the icon
will revert to white and the current fan speed will remain on indefinitely.
•
The maximum timer program cycle is 9 minutes: 5 minutes on 3 and then 2 minutes each on speed 2
down to speed 1.
03 Controlling the cooker hood remotely
IMPORTANT: This section is only applicable if you have also purchased a
compatible hob with Radio Frequency (RF) capability. Contact the Customer
Helpline at the end of this manual for compatible models.
The process for connecting the hood to the hob happens in three stages:
A) Configure the hob to transmit a radio frequency signal.
B) Configure the hood to receive this signal.
C) Lock the connectivity between the two appliances and complete the pairing process.
IMPORTANT: Complete this set up within two minutes of turning on the
Residual Current Device (RCD).
04 Controlling the cooker hood from your hob
Ensure the hob and hood connectivity has been completed and the Hood connection button is ON!
1. Make sure that the hob and the hood are switched off.
2. Turn on the hob and make sure the connectivity indicator is lit.
NOTE: Touch the connectivity key on the hob if it is not lit.
5059340446028_MNL_IN_V04.indb 71
5059340446028_MNL_IN_V04.indb 71
or Speed Increase icon
71
during a current timer program will
8/6/2022 3:15 PM
8/6/2022 3:15 PM
Publicidad
