Publicidad
Idiomas disponibles
Idiomas disponibles
EN Care & maintenance
IMPORTANT: Turn off the power at the Residual Current Device (RCD) before
replacing the carbon filters.
01 Carbon filter replacement
Replace carbon filters every three months.
To change the carbon filters:
3 MONTHS
Use two carbon filters, model CARBFILT4 3663602843092 available from the Customer helpline.
See the Care & Maintenance section for details.
If the motor is off, and after the fan has been in operation for approximately 150 hours, the display will show
and the Timer will flash red to advise you to replace the carbon filters. After replacing the filters, reset the
alert by pressing the Timer
WARNING: Always switch off the electrical supply before carrying out
maintenance work on the hood. In the event of a fault, contact customer
services.
02 Aluminum grease filter cleaning
Aluminium filters: To avoid fires, clean thoroughly once a month. Remove the grease filter as shown and
soak in hot water and detergent for an hour. If using a dishwasher position the filters vertically to improve the
cleaning process.
1 MONTH
If the motor is off, and after the fan has been in operation for approximately 50 hours, the display will show
and the Timer will flash red to advise you to clean the aluminum grease filters. After cleaning the filters,
reset the alert by pressing the Timer
WARNING: : Increase the filter cleaning/replacement frequency if the hood
is used for more than 2 hours a day. Always use genuine filters from the
manufacturer.
5059340446028_MNL_IN_V04.indb 94
5059340446028_MNL_IN_V04.indb 94
CARBFILT4
icon.
icon.
94
≤ 65 °C
8/6/2022 3:15 PM
8/6/2022 3:15 PM
Publicidad
