Kingfisher CLAG60LKBL Manual De Instrucciones página 73

3. Turn on the hood, press and hold both Speed icons
4. Press and hold the Timer icon
will flash in the display.
5. Press the two front cooking zone keys together on the hob and the connectivity indicator will flash to
confirm connection.
6. The control panel of the hood will show "A" for five seconds to indicate connectivity has been made with
the hob.
7. Press the two front cooking zone keys together on the hob before "A" disappears to store the
connectivity settings.
IMPORTANT: The extraction rate of the hood will vary based upon the total
power output selected on the hob, as shown in the table below.
Each hob cooking zone has a maximum rated output of 10 comprising 1-9 and
Boost (10).
Speed Level of the Hood
Speed 1
Speed 2
Speed 3
NOTE:
• The table listed in the compatible hob manual is for guidance only, please refer to this table only for
speed control.
• During connectivity, the lamp will be turned on and off simultaneously with the fan. If the hood controls
are manually overridden when the hob and hood are linked, the hood will operate for five minutes on this
manual setting before returning to control by the hob.
• To reconnect the hood and hob immediately, turn off the fan and the hood will automatically reconnect to
the hob again.
Stopping the connectivity function
1. Touch the connectivity key on the hob, the indicator light will go out and the link will be dropped.
To reconnect again, press the connectivity key on the hob again.
2. If the hob is switched off, the hood will continue to operate independently in Timer mode and the current
speed will flash. The current speed level of the hood will continue for 5 minutes and step down for
2 minutes at each level until finally switching off.
5059340446028_MNL_IN_V04.indb 72 5059340446028_MNL_IN_V04.indb 72
and Light icon together for 3 seconds on the control panel and "A"
Combined Power Output of the Hob
This speed will be selected when there are no more than two cooking zones
in use, and the combined output is 8 or less. For example, zone 1 is on 2,
and zone 2 is on 5.
This speed will be selected when there are no more than three cooking
zones in use, and the combined output is between 9 and 24. For example,
zone 1 is on 7, zone 2 is on 6 and zone 3 is on Boost (10).
This speed will be selected when more than 3 cooking zones are in use, and
combined output is 25 or higher.
72
together for 3 seconds to enter Set Up mode.
8/6/2022 3:15 PM 8/6/2022 3:15 PM