Flex FX3211 Manual Del Operador página 11

WARNING
performing any assembly or adjustments, or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
TO ATTACH/DETACH BATTERY PACK (FIG. 2)
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool.
NOTICE: When placing the battery pack onto
the tool, be sure that the raised rib on the
battery pack aligns with the groove inside
the tool and that the latches snap into place
properly. Improper attachment of the battery
pack can cause damage to internal components.
To detach the battery pack:
Depress the battery-release button located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool.
INSTALL AND REMOVE ACCESSORIES
(FIG. 3, 4 AND 5)
Always be sure that the
WARNING
battery pack is removed before carrying out
any work on the tool.
WARNING
installed collet. Smaller shanks will not be
secure and could become loose during
operation. Ensure that the accessories used
meet the working conditions.
WARNING
during use. Wear gloves when changing
accessories.
To install the accessory
a. Remove the battery pack.
b. Clean the grinding spindle and all the parts to
be fitted.
c. Press the spindle-lock button, loosen the
collet nut using the collet wrench and turning it
counterclockwise (Fig. 3).
Detach the battery pack
from the tool before
tool is switched off and the
Only use accessories with
shanks that match the
Danger of burns! The
accessories will become hot
ASSEMBLY
Fig. 2
Battery-Release
Button
Battery Pack
Fig. 3
Collet
Wrench
Spindle-Lock
Button
-11-
Collet
Nut