Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORIES
Points, cones, plugs, grinding wheels and cut-
off wheels should be protected from:
Wetness and extreme humidity.
•
Any type of solvent.
•
Extreme changes in temperature.
•
Dropping and bumping.
•
Points, cones, plugs, grinding wheels and cut-
off wheels should be stored:
In an organized way so points, cones, plugs or
•
wheels can be removed without disturbing or
damaging other points, cones, plugs or wheels
With their safety information.
•
Points, cones, plugs, grinding wheels and cut-
off wheels should NOT be dropped, rolled or
bumped.
Discard points, cones, plugs, or wheels that
have been dropped, rolled, bumped, subjected
to extreme changes in temperature, or come
into contact with solvents or wetness.
WARNING
accessories, others may be hazardous.
GENERAL APPLICATION (FIG. 10)
WARNING
with side shields during power tool
operation or when blowing dust. If operation
is dusty, also wear a dust mask.
WARNING
accessory or collet nut when it is running!
WARNING
will become hot during use. Wear gloves when
changing accessories or touching workpiece.
Keep hands away from the grinding area at all
times.
WARNING
that no combustible material is present in the
work area.
a. Attach the battery pack.
b. Set a speed that is suitable for the application
and accessory. If you have just installed an
accessory or are beginning a period of work,
test it by letting it spin for one minute before
applying it to the workpiece.
Contact a distributor to
buy only recommended
Always wear safety
goggles or safety glasses
Never reach into the
proximity of the rotating
Danger of burns! The
accessories and workpiece
Sparks generated when
grinding metal. Make sure
c. Use a clamp, vise or other practical means to
hold your workpiece.
d. Firmly grasp the tool.
e. Start the tool before applying it to workpiece
and let the tool come to full speed before
contacting the workpiece.
WARNING
balance or damaged accessories can mar
workpiece, damage the tool, and cause stress
that may cause accessory failure.
f. Move the tool evenly back and forth with
light pressure to achieve an optimum work
result. Pressure that is too strong reduces the
performance capability of the tool and causes
the tool to wear more quickly.
g. Lift the tool from the work before releasing the
switch. DO NOT turn the switch ON and OFF
while the tool is under load – this will greatly
decrease the switch life.
h. If the tool begins vibrating, immediately stop
the motor and check to see if the accessory
is dull. Dull accessories will cause the tool
to vibrate and could force the collet to fly
off the tool. Always replace or sharpen dull
accessories.
i. Accessories are design for specific uses, only
use points, cones, plugs, grinding wheel and
cut-off wheels for applications for which they
were designed. Follow manufacturer's care
and use instructions.
Fig. 10
-16-
Never use an accessory that
has been dropped. Out-of-
Publicidad
